Monthly Archives: June 2017

Audio-widget & FreeDSP

I got a board combining the two from a member of DiyAudio. The board had some errors and I didn’t get any BOM. Anyway, I’ve begun populating the board. The main problem is that most of my SMD resistors and capacitors … Continue reading

Posted in Uncategorized | Leave a comment

Audio-widget

First board programmed and recognized as an USB audio device šŸ™‚ /Mayday

Posted in Uncategorized | Leave a comment

Main stereo up and running :)

Got rid of the hum in the left B&G Neo 8 by swapping the Arcam Alpha 8 power amp for a DIY TA2022 amp in stereo mode. PS for this amp is 2*22vac 400VA toroidal transformer from toroidy, followed by a … Continue reading

Posted in Uncategorized | Leave a comment

Main system up and running…

…well I have sound from all drivers. I have some hum in the left HF, the one previously silent. The sound was a bit anemic, but given new filter capacitors and cold amps that’s to be expected. I need to … Continue reading

Posted in Uncategorized | Leave a comment

My beloved dipole speakers.

My beloved dipole speakers are getting some TLC in the form of new caps in the crossover (mids/highs). The highs are handled by the not unknown B&G Neo 8 magnetostats. Mids are handled by Dayton Reference series aluminium drivers. RS180S-8 … Continue reading

Posted in Some old projects. | Leave a comment

Re-capped crossover

The first crossover board is etched and drilled and I have populated the MKP’s. JB JFX Premium series from hifi-collective The PCB is 10*15cm 70u Cu. Caps are: 68uF, 20uF and 10uF. /Mayday

Posted in Uncategorized | Leave a comment

Last couple of days

I’ve been in too much pain to do any real DIY. I did collect the acousticly transparent fabric that I will stretch over a wooden “box” frame, think upside down box with cloth walls. I’ll fasten the fabric with a … Continue reading

Posted in Uncategorized | Leave a comment